Carton packaging machinery maintenance points

Carton packaging machinery is suitable for all kinds of carton production and processing, commonly used are 30 and 40 two, the form of heat source is coal or firewood and electric type. It is the most commonly used machinery in carton processing. Its maintenance and repair points are as follows:

First, replace the lubricating oil in the worm gearbox of the carton packaging machinery. Lubricating oil can be used with No.10, No.20 or No.30 engine oil.

2. After the components are repaired, the Machine is assembled and turned on to check whether the machine is operating normally. Heat the rollers properly and put a small amount of special oil for the carton packaging machine to melt and cover the inner surface of the cylinder. Then cut off all the power. If necessary, The surface of the machine is sprayed with paint, dried and covered with plastic paper, and stored in a dry place.

Third, if the chain is too loose, you can first take a few ways to remove the adjustment, if it has been seriously elongated, it should be replaced. In the use of carton machinery should be used in accordance with a certain amount of principle and principle, in accordance with a certain way of maintenance And maintenance, timely solution to different fault problems, attention should be paid when adjusting and replacing the chain: The installation direction of the spring card at the chain joint should be consistent with the running direction of the chain so as to avoid impact, beating or even falling off during operation.

Fourth, remove and wash all the rolling bearings, and add new grease, can use calcium sodium grease.

5. Remove all dirt on the friction surface, especially the chain and sprocket, and refill the lubricant. Maintenance and maintenance of carton packaging machinery Repair and maintenance must be done by certain technicians to ensure that the carton machinery is in use. The quality and performance play an important role and value in the production of cartons.

6. Check whether the stove is leaking smoke. If any smoke is found, check the drum stop ring, stove and chimney, and find that the damage should be promptly repaired and replaced. The electric heater type should check whether the electric heating tube is damaged or not. replace.