What should I do if the hand drying rack fails? Mrs. Qiao will give you analysis and solution.

1. Feeling a lot of resistance during operation, it is very hard to shake or simply do not move, let you coercive. When it is very difficult to shake, it is generally judged that the inner wire is disordered. Because the inner cavity is small, the inner wire is too late to be folded during the process of the user's drawing too fast, and the outer wire becomes crowded. The inner and outer steel wires are disorderly folded, causing the local steel wire to bulge and directly rub against the inner cavity wall to generate resistance. At this time, if the situation is unclear, the wire will be completely entangled, and the wire will be completely shaken. Therefore, when the shaking is laborious, the steel wire can be slowly withdrawn. In the process of retreating, one hand firmly grasps the hand shaker, and the other hand pulls the wire rope slowly and outwards; When the hand crank is shaken and the hand crank is not moving, you can use the tool to open the inner cavity of the hand crank, then clean the wires that are entangled together, and let the wires of each layer be completely returned, and then reinstall. A good hand shaker is all right.

Hand drying rack repair method

2. When the clothes are hung up and the clothes rack is shaken up to a high position, the handcuffs are found to be fixed. What should I do at this time? Is it a silly, stupid caller or a friend, or is it rushing to the Internet for help? When the above situation occurs, the general reason is that the steel bowl of the hand crank is naughty and runs away from the original position, because the various components in the inner cavity of the hand crank are cooperatively cooperated. When the steel bowl is out of position, the inner cavity The coil spring was not happy, indicating a firm strike, so turning the parts was like a dislocated horse, and no one locked it. At this point, we can use the tool to carefully open the cavity, pay attention to gentle sputum, or damage the delicate and fragile aluminum parts will not be worth the loss. After the inner cavity is opened, hook one end of the spring to the tab in the steel bowl, which is the raised part. After re-tightening it, put it into the steel bowl again, and then hook the other end of the spring. Inside the column, and insert the positioning heel of the spring steel bowl into the corresponding bayonet, and then gently press it. After these steps are completed, the wire rope of the handle shaker is wound on the axle, taking care not to wrap too much, and finally the handle The bottom plate of the shaker is installed and you're done.

In fact, the problems encountered in life are not difficult. The important thing is to take the time to study and be willing to go to special research. I believe that even a small family at home will become a small expert at home.

Editor: China drying rack net - Taitai