DANA DESIGN sewing standard [Figure] Read more >>
One. Sewing
1. Slit 10MM.
2. Clear side distance 2-3MM.
3. æ’¸ along the side of the line 8MM.
4. All joint error is 1MM.
II. General requirements
1. 1 inch 9 stitches when sewing.
2. 1 inch and 6 stitches when hanging.
3. æ’¸ æ’¸ 1 inch 7 pin.
4. Foam 1 inch 6-pin.
5. At the beginning and end of the line, you must play 6 mm of the reversed needle 1 time (1 pour 3 lines).
6. The pin number on the trademark is also 1 inch 8-10MM.
7. When you go to the zipper, you have to make a 25mm long needle.
8. All the needles must be three lines.
Three. Line
Line to use #69 Nylon Bonded's line
The tightness of the thread should be suitable, not too loose and too tight.
The thread can not be longer than 3MM.
The thread must be removed before the bow.
IV. Needle
Only round needles can be used.
V. Oxford Band
All Oxford lead must be hot, no flash.
All Oxford lead fold 3.5CM, tie line from Oxford lead 1.75CM.
The extra parts of Oxford's seams should be folded over, and they should be sewn along the back of the child, and should not be burned.
The Oxford band that was folded over will show its head.
Six. Symmetry
To be symmetrical around, the maximum error is 10MM.
Seven folds
Wrinkles are not allowed.
Eight. Along the child.
The joint is 10MM, and the edge is 8MM.
A 25mm needle is needed to start and end the child.
9. Seams
The open line and double needles are not allowed to break.
If the seam is broken, it will be sewn with 3CM stitches.
Ten knotted
Knotted with 42 stitches.
20MM Oxford with a knot width of 15MM.
25MM and 50MM Oxford tie knot width 20MM.
Knotting can't be played on the edge of Oxford.
4. The knots on the seams are to be played on the strands.
Super Micro Bubble Beauty Instrument,Rf Ems Beauty Instrument,Rf Beauty Instrument,Rf & Ems Beauty Instrument
Foshan Liqia Hardware Products Co., Ltd. , https://www.liqiamei.com