Solve the problem of changing the print speed

In general, when the continuous ink supply system is reformed, the original ink cartridges will also be reformed, which will inevitably cause a burden on the car. When the load is overloaded, the vehicle will act slowly, and the overload will also lead to accelerated aging of the printer belt and increase the friction between the carriage and the connecting rod, which will cause the printing speed to slow down. Seriously, it may cause the word carriage to fail to reset and then become unusable.

There are three ways to resolve this failure:

a. When replacing the motor, when the hose of the continuous ink supply system rubs against the wall of the printer, resulting in an increase in the load of the electric motor and long-term use of the electric motor, we must try to replace it;

b. Lubricate the connecting rod. Sometimes low-speed printing is due to a long time of use. The friction between the word carriage and the connecting rod in the machine becomes large, and the resistance increases to cause the electric motor to run slowly. At this time, lubrication of the connecting rod can solve the problem. ;

c. The aging of the belt of the printing equipment, which drives the gear friction force connected to the motor, accelerates the belt aging of the printer. Cleaning and lubrication at this time can reduce the failure of the belt aging.

There is also a need to pay attention to pay attention to even the supply line, do not cause drag to cause the car to be blocked. Because the internal structure of different printers is somewhat different, and does not provide support for conversions, the problem of cabling has become the most problem encountered in the conversion of CISS.